NIDEC COMPONENTS products lineup, You can refer to the detail of Slide switch ASE. ASE1D-2M-10-Z,ASE1E-2M-10-Z,ASE2D-2M-10-Z,ASE2E-2M-10-Z,ASE2N-2M-10-Z,ASE1D-5M-10-Z,ASE2D-5M-10-Z,ASE1D-6M-10-Z,ASE2D-6M-10-Z,ASE2N-6M-10-Z ASE-1D-2M-10-Z,ASE-1E-2M-10-Z,ASE-2D-2M-10-Z,ASE-2E-2M-10-Z,ASE-2N-2M-10-Z,ASE-1D-5M-10-Z,ASE-2D-5M-10-Z,ASE-1D-6M-10-Z,ASE-2D-6M-10-Z,ASE-2N-6M-10-Z 140000640324
全部替代型号
查看完整报告技术参数
| 环境与封装 | |
|---|---|
| Mounting of Switch | Use the PC boards of φ1 holes. Do not bend the terminals before mounting the switch on the PC board. After mounting the switch, do not place the device in such a way that the device weight will be applied on the knob, etc. of the switch. Do not apply load exceeding 12.7 N (1.3 kgf) to the knob. Use a bracket (optional accessory) if the load is expected to exceed 12.7 N (1.3 kgf). The strength of the knob will be reinforced to 29.4 N (3 kgf) max. |
| Operating temperature range | - 20 ℃ ~ ＋ 85 ℃ |
| Storage temperature range | - 40 ℃ ~ ＋ 85 ℃ |
| 其他 | |
| Dielectric strength | 250 VAC 1 minute |
| Electrical life | 10,000 cycles at max. rating. 50,000 cycles at min. rating or 0.4 VA |
| Flux Cleaning | Solvent : Fluorine or Alcohol type. Cleaning after soldering should be done after the terminal temperature falls to 90℃ or below, or after leaving the switch for five minutes or longer at room temperature. Do not use ultrasonic cleaning system |
| Initial contact resistance | 50 mΩ max. (1.5mA 200 μVAC） |
| Initial insulation resistance | 500 MΩ min. (500 VDC） |
| Operating force | 0.69 ~ 4.9 N |
| Rating 0.4VA AC/DC | Voltagr range:20 mV ~ 60 V Current range:1 μA ~ 50 mA |
| Rating Max. | 60 VAC / DC 50 mA |
| Rating Min. | 20 mVAC / DC 1μA |
| Rating UL | 48 VAC / DC 50 mA |
| Soldering Specifications | Manual Soldering / Device: Soldering iron 380 ℃, Max.; 3 seconds, Max. Auto Soldering: Device: Jet wave type or dip type 275 ℃, Max.; 6 seconds, Max. Pre-heating should be done at temperatures ranging from 80 ℃ to 120℃ and within 120 sec. |