SWD60

Active

TAKEX Product Information: Photo Sensors for Steel and Heavy Industries series published on the official product catalog.

See alternatives Ask AI FAE

All alternatives

View full report

Technical parameters

Power
Power consumption	30W or less
Power supply	100, 110, 200 or 220 VAC (rated voltage : ?15+10%, 50/60 Hz)
Environment and package
Ambient temperature	-25°C to 55 °C (Non-freezing)
Storage temperature	-40°C to 70 °C (Non-condensing)
Other
ALARM output operation mode	Output rating : Relay output 250VAC 5A or less (resistive load)
Ambient humidity	35 - 85%RH (Non-condensing)
Connection	Terminal block
Control output	Single-hole detection output : Relay output 1c and NPN open collector output (floating) Double-hole detection output : Relay output 1c and NPN open collector output (floating)
Description	Controller
Dielectric withstanding／Insulation resistance	Between power supply and case Between relay output and case Between relay output and power supply 1500 VAC for 1 minute, 20 MΩ or higher (with 500 VDC) Between open collector output and case Between open collector output and power supply 1000 VAC for 1 minute, 20 MΩ or higher (with 250 VDC)
Model	Type
Operation mode	One shot output : duration variable between 0.1-1 second (adjustment volume on panel)
Output rating	Relay output : 250 VAC 5 A or less (resistive load) NPN Open collector output : 30VDC 100mA or less
Protective structure	IP40 (with case)
Receiver check input	a (normally open) contact input (short circuiting of Terminals 9 and 10)
Response time	Relay output : 30 ms or less NPN Open collector output : 3ms or less
SAFETY output	Relay output 1a Output rating : 250 VAC 5 A or less (resistive load)
Shock	500m/s2/ 3 times each in 3 directions
SWD60	For single and double hole detection
Type	For single and double hole detection
Vibration	10-55 Hz / 1.5 mm double amplitude / 2 hours each in 3 directions
Weight	Approx. 9 ㎏

Documents

No documents are linked to this part yet.