Все аналоги
Полный отчётТехнические параметры
| Питание | |
|---|---|
| No-load supply current | I 0 | ≤ 60 mA |
| Operating voltage | U B | 10 ... 30 V DC , ripple 10 % SS 15 ... 30 V voltage output |
| Output current | < 12 mA |
| Power consumption | P 0 | ≤ 1 W |
| Rated operating current | I e | 200 mA , short-circuit/overload protected |
| Voltage drop | U d | ≤ 2.5 V |
| Характеристики по постоянному и переменному току | |
| 0 Level 0 ... 1 V 1 Level 4 V ... U B Input impedance > 12 kΩ Output current < 12 mA Pulse length 0.5 ... 300 ms (level 1) Pulse interval ≥ 74 ms (level 0) | 0 Level | 0 ... 1 V | 1 Level | 4 V ... U B | Input impedance | > 12 kΩ | Output current | < 12 mA | Pulse length | 0.5 ... 300 ms (level 1) | Pulse interval | ≥ 74 ms (level 0) |
| Input impedance | > 12 kΩ |
| Load impedance | current output: ≤ 300 Ohm voltage output: ≥ 1000 Ohm |
| Repeat accuracy | ≤ 0.1 % of full-scale value |
| Resolution | current output: evaluation range [mm]/3200 but ≥ 0.35 mm voltage output: evaluation range [mm]/4000 but ≥ 0.35 mm |
| Response delay | minimum : 140 ms factory setting: 280 ms |
| Switching frequency | f | ≤ 1.5 Hz |
| Time delay before availability | t v | ≤ 200 ms |
| Transducer frequency | approx. 65 kHz |
| Условия эксплуатации и корпус | |
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) |
| Temperature influence | ≤ 1.5 % from full-scale value (with temperature compensation) ≤ 0.2 %/K (without temperature compensation) |
| Другое | |
| 0 Level | 0 ... 1 V |
| 1 Level | 4 V ... U B |
| Adjustment range | 400 ... 6000 mm |
| Beam width | wide |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| Common mode operation | ≤ 13 Hz |
| Common mode operation ≤ 13 Hz Multiplex operation ≤ 14 Hz / n , n = number of sensors , n ≤ 10 (factory setting: n = 5 ) | Common mode operation | ≤ 13 Hz | Multiplex operation | ≤ 14 Hz / n , n = number of sensors , n ≤ 10 (factory setting: n = 5 ) |
| Connection type | Connector plug M12 x 1 , 5-pin |
| Cycle time | min. 72 ms |
| Dead band | 0 ... 350 mm |
| Degree of protection | IP67 |
| Deviation of the characteristic curve | ≤ 0.2 % of full-scale value |
| Diameter | 73 mm |
| Housing | Stainless steel 1.4305 / AISI 303 TPU Polyamides |
| Housing Stainless steel 1.4305 / AISI 303 TPU Polyamides Transducer epoxy resin/hollow glass sphere mixture; polyurethane foam | Housing | Stainless steel 1.4305 / AISI 303 TPU Polyamides | Transducer | epoxy resin/hollow glass sphere mixture; polyurethane foam |
| Input/output type | 1 synchronization connection, bidirectional |
| Interface type | IO-Link |
| LED green | solid: Power on flashing: Standby mode or IO link communication |
| LED red | solid red: Error red, flashing: program function, object not detected |
| LED yellow 1 | solid: Object in evaluation range flashing: Learning function, object detected |
| LED yellow 2 | solid: Object in evaluation range flashing: Learning function, object detected |
| Length | 106 mm |
| Length 106 mm Diameter 73 mm | Length | 106 mm | Diameter | 73 mm |
| Mass | 165 g |
| Mode | COM2 (38.4 kBit/s) |
| Multiplex operation | ≤ 14 Hz / n , n = number of sensors , n ≤ 10 (factory setting: n = 5 ) |
| Non-volatile memory | EEPROM |
| Output 1 | near switch point: 400 mm far switch point: 6000 mm Output mode: Window mode output behavior: NO contact |
| Output 2 | near limit: 500 mm far limit: 3000 mm Output mode: rising ramp output behavior: Current output 4 mA ... 20 mA |
| Output type | 1 push-pull (4 in 1) output, short-circuit protected, reverse polarity protected Current output 4 mA ... 20 mA or voltage output 0 V ... 10 V configurable |
| Process data width | 16 bit |
| Protocol | IO-Link V1.0 |
| Pulse interval | ≥ 74 ms (level 0) |
| Pulse length | 0.5 ... 300 ms (level 1) |
| Range hysteresis | H | 1 % of the adjusted operating range (default settings), programmable |
| Sensing range | 350 ... 6000 mm |
| SIO mode support | yes |
| Standards | EN IEC 60947-5-2:2020 IEC 60947-5-2:2019 EN 60947-5-7:2003 IEC 60947-5-7:2003 |
| Standards EN IEC 60947-5-2:2020 IEC 60947-5-2:2019 EN 60947-5-7:2003 IEC 60947-5-7:2003 | Standards | EN IEC 60947-5-2:2020 IEC 60947-5-2:2019 EN 60947-5-7:2003 IEC 60947-5-7:2003 |
| Standard target plate | 100 mm x 100 mm |
| Transducer | epoxy resin/hollow glass sphere mixture; polyurethane foam |
| Transfer rate | Acyclical: typical 44 Bit/s |
| UL approval | cULus Listed, Class 2 Power Source |
| Write cycles | 100000 |
Изображения
Документы
К этому компоненту пока не привязаны документы.