Pepperl+Fuchs, Inc.Германия
83637
ПроизводитсяHF RFID read/write device with IO-Link in accordance with ISO 15693
Все аналоги
Полный отчётТехнические параметры
| Питание | |
|---|---|
| No-load supply current | I 0 | ≤ 70 mA (at 24 V DC) |
| Power consumption | P 0 | ≤ 2 W |
| Rated operating voltage | U e | 20 ... 30 V DC , ripple 10 % SS |
| Характеристики по постоянному и переменному току | |
| Operating frequency | 13.56 MHz |
| Условия эксплуатации и корпус | |
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) |
| Directive 2011/65/EU (RoHS) | IEC/EN 63000 |
| Directive 2011/65/EU (RoHS) IEC/EN 63000 | Directive 2011/65/EU (RoHS) | IEC/EN 63000 |
| Height | 12 mm |
| Height 12 mm Width 28 mm Length 80 mm | Height | 12 mm | Width | 28 mm | Length | 80 mm |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) |
| Другое | |
| Cable length | 20 cm |
| Communication interface | IEC 61131-9 / IO-Link V1.1.2 |
| Compatible master port type | Class A Class B |
| Connection | connector M12 x 1 |
| Data transfer rate | COM3 (230.4 kbits/s) |
| Degree of protection | EN 60529 |
| Device ID | 4194561 (0x400101) |
| Directive 2014/53/EU | EN 301489-1 EN 301489-3 EN 300330 EN 62368-1 EN 50364 |
| Directive 2014/53/EU EN 301489-1 EN 301489-3 EN 300330 EN 62368-1 EN 50364 | Directive 2014/53/EU | EN 301489-1 EN 301489-3 EN 300330 EN 62368-1 EN 50364 |
| Distance between two heads | ≥ 150 mm |
| Distance between two heads ≥ 150 mm | Distance between two heads | ≥ 150 mm |
| Encapsulation compound | WEVO 403FL/300 |
| FCC approval | This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. |
| Housing | PBT |
| Housing PBT Encapsulation compound WEVO 403FL/300 | Housing | PBT | Encapsulation compound | WEVO 403FL/300 |
| IC approval | This device complies with Industry Canada licence-exempt RSS standard(s) and with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. |
| Interface type | IO-Link |
| IO-Link revision | 1.1 |
| KCC approval | R-R-PF1-IQT1-F61-IO-V1 |
| LED blue | Write/read attempt is being performed |
| LED green | Illuminated: power on Flashing: IO-Link communication |
| LED red | Flashing: IO-Link communication interrupted |
| LED yellow | Data carrier detected |
| Length | 80 mm |
| Mass | approx. 60 g |
| MIC approval | AC-21097 |
| Min. cycle time | 4 ms |
| MTBF | 140 a (Operation at +40 °C) |
| Process data | Input 32 Byte Output 32 Byte |
| Radio approval | USA: FCC IREIQT1F61IO Canada: IC 7037A-IQT1F61IO |
| Read distance | 0 ... 55 mm |
| Read distance 0 ... 55 mm Write distance 0 ... 55 mm Width max. 45 mm | Read distance | 0 ... 55 mm | Write distance | 0 ... 55 mm | Width | max. 45 mm |
| RFID | ISO/IEC 15693-2 ISO/IEC 15693-3 ISO/IEC 18000-3 |
| SIO mode support | no |
| Transfer rate | 26 kBit/s |
| UL approval | E87056 cULus Listed, Class 2 Power Source, Type 1 enclosure |
| Vendor ID | 1 (0x0001) |
| Width | max. 45 mm |
| Write distance | 0 ... 55 mm |
Изображения
Документы
К этому компоненту пока не привязаны документы.